Bixolon Q300 Wi-Fi Printer Setup

Setup via usb initially and Software_NetConfigurationTool_V3.3.1_EN in dropbox > printers > bixolon folder.

See video for instructions and also steps below:

1. Plug in printer via usb cable - do not install any drivers
2. Open net configuration tool
3. Select wlan (advanced) tab
4. connect
5. usb should be selected and port should show BIXOLON SRP-Q300
6. Press connect - it should show information
7. Select WLAN Mode to infrastructure and then select SSID (... next to it) should now display a list of Wifi networks - once selected should fill in authentication/encryption type
8. Enter in wifi password
9. Set Ip address configuration to dhcp temporarily
10. Press Save - this will send info to printer
11. Restart printer (turn off and on)
12. On net configuration tool reconnect via usb to printer and see if it now has an ip address
13. Browse this ip on the till and make sure you can connect (username: admin - password: password)
14. Select Network and turn off dhcp and allocate static ip (check it is spare) and save
15. turn printer off and on
16. unplug usb cable from printer
17. Test sale.